![]() Click the TEST bar and adjust the speaker’s volume control, mic preamp gain or the on-screen slider until the bar indicator is in the OK range, again click NEXT to load the Measurement screen (see Photo 4). The Step 3 screen (see Photo 3) sets the measurement sound level. Select your audio hardware (sound card) and click NEXT. The Step 2 screen (see Photo 2) is Audio setup. ![]() You are then asked to select a microphone, click the MEMS mic and click NEXT. ![]() The measurement module’s first screen is simply introductory, click NEXT. When you have completed the seventh step, you will have the option to save your data or you can continue taking measurements. If the measurement is okay, the arrow will move to “Box 2.” Move your mic and continue the process. The small vertical arrow is under “Box 1.” Make sure your mic is in location one and press the TAKE MEASUREMENT bar. Photo 4: Screen 4 is where you make the measurements.
0 Comments
Leave a Reply. |